Kenmore Elite slide-in electric range, 3-digit codes error codes:

These error code explanations can help diagnose a problem on a Kenmore Elite slide-in electric range with a model number starting with 790.4671.

Error codes appear on the control panel display when the electronic oven control board detects component failures.

When you see an error code appear, look up the cause of the code and the DIY troubleshooting advice in the chart below to help you fix your slide-in range.


Code Meaning Possible Cause Possible Parts
F10 Runaway temperature (oven temperature is over 600 degrees F and increasing) Disconnect power from the range. Check the resistance of the oven temperature sensor using a multimeter. You should measure about 1,100 ohms resistance through the sensor at room temperature. If not, replace the sensor. If the oven overheats and the oven temperature sensor is okay, replace the oven control board because a stuck relay on the control board is causing the oven to overheat Oven temperature sensor, oven control board
F11 Stuck key on the touch control panel The control detects a stuck key. Make sure nothing is pushing against the keypad. Press the Stop key to clear the display. If the code won't clear, disconnect electrical power to the range and check the wire harness connections between the touch control panel and the oven control board. Reconnect any loose wires. If the wiring is okay, replace the touch control panel. If the problem continues, replace the oven control board Touch control panel, oven control board
F13 Oven control board failure Disconnect electrical power, wait 30 seconds and restore power. If the error code returns, replace the oven control board Oven control board
F14 Communication error between the oven control board and touch control panel Disconnect electrical power and check the wiring connections between the touch control panel and oven control board. Reconnect any loose wires. If wiring connections are okay, replace the oven control board. If the problem continues, replace the touch control panel Oven control board, touch control panel
F15 Oven control board failure Disconnect electrical power, wait 30 seconds and restore power. If error code returns, replace the oven control board Oven control board
F20 Communication failure between the oven control board and the user interface control board Disconnect electrical power and check the wiring connection between the user interface control board and the oven control board. If the wiring connection is okay, replace the user interface control board. If the error code returns, replace the oven control board User interface control board, oven control board
F30 or F31 Oven temperature sensor failure Disconnect power from the range. Check the resistance of the oven temperature sensor probe using a multimeter. You should measure about 1,100 ohms of resistance through the sensor probe at room temperature. If not, replace the sensor probe Oven temperature sensor
F90 Oven door lock failure If the oven door won't lock or unlock, disconnect power, wait 30 seconds and restore power. Try again to lock it by activating the oven lockout feature or starting a clean cycle. If the door wouldn't unlock, try to unlock it by pressing the cancel button. If the door lock motor doesn't run, disconnect power to the range and check the wire harness connections between the door lock assembly and the oven control board. Reconnect any loose wires or replace the wire harness if damaged. If the wiring is okay, replace the door lock assembly. If the problem continues, replace the relay control board Oven door lock assembly, wire harness, oven control board


Kenmore / Sears Range / Cooktop / Oven Parts

Kenmore Elite Range / Cooktop / Oven Parts

Kenmore Pro Range / Cooktop / Oven Parts


Related Links

  1. Kenmore / Sears Range / Cooktop / Oven Fuse or Sensor Parts
  2. Kenmore / Sears Range / Cooktop / Oven Terminal Block, Receptacle Parts
  3. Kenmore / Sears Range / Cooktop / Oven Burner & Related Parts