Kenmore 796. model dryer Repair Help

Kenmore 796. model dryer error codes:

Reference Model: None

These error code explanations can help you diagnose a problem with your Kenmore 796. dryer.

When a failure occurs, you'll see the error code flashing on the digital display of your dryer.

Find the error code displayed on your Kenmore 796. dryer's control panel in the chart below and follow the troubleshooting tips to fix the problem.

Code	Meaning	Possible Cause	Possible Parts
tE1	Thermistor failure	The electronic control detects that the thermistor (temperature sensor) has failed. Unplug the dryer and measure the resistance through the thermistor. It should measure about 10,000 ohms at room temperature. If the thermistor is defective, replace it	Thermistor
tE2	Thermistor failure	The electronic control detects that the thermistor (temperature sensor) has failed. Unplug the dryer and measure the resistance through the thermistor. It should measure about 10,000 ohms at room temperature. If the thermistor is defective, replace it	Thermistor
dE	Door switch error	Check the operation of the door switch using the diagnostic test mode, which is explained in the tech sheet that's typically stored in the console of the dryer. If the door switch is defective, replace it	Door switch

Kenmore / Sears Dryer Parts

Kenmore Elite Dryer Parts

Kenmore Pro Dryer Parts

IMPORTANT DISCLAIMER: The Author of this web site assumes no responsibility for inconveniences or damages resulting from use of the information he supplies. The consumer or reader is individually responsible for his or her use of the information supplied and uses this information at their own risk. The author of this site has no liability for errors, omissions, or any defects whatsoever in the information or instructions, or for any damage or injury resulting from the utilization of said information or instructions....

Appliance Repair Help:

Kenmore 796. model dryer error codes:

Copyright © 2000-2025 ApplianceAid.com. All rights reserved.