Electrolux dishwasher error codes:
Reference Model: None
| Code | Meaning | Possible Cause | Possible Parts |
| Er-01 | Water leak detected | A sensor under the dishwasher detected a leak. Shut off power to the dishwasher. Inspect all hoses, pumps and the tub to find the leak. Replace the leaking parts | Drain hose, drain pump, recirculation pump |
| Er-02 | Thermistor/turbidity sensor failure | Shut off power to the dishwasher and check the wiring for the thermistor/turbidity sensor circuit. If the wiring is okay, replace the thermistor/turbidity sensor | Thermistor/turbidity sensor failure |
| Er-03 | Wash motor failure | Shut off power to the dishwasher and then check the wiring for the wash motor. If the wiring is okay, check for an obstruction in the pump. Replace the wash motor if the pump is clear and the wiring is okay | Wash motor |
| Er-04 or Er-05 | Upper fan/vent failure | Shut off power to the dishwasher and check the wiring for the upper fan/vent. If the wiring is okay, replace the upper fan/vent | Upper fan/vent |
| Er-06 | Lower fan failure | Shut off power to the dishwasher and check the wiring for the lower fan. If the wiring is okay, replace the lower fan | Lower fan |
| Er-07 or Er-11 | Drain valve failure | Shut off power to the dishwasher and check the wiring for the drain valve. If the wiring is okay, replace the drain valve | Drain valve |
| Er-08 | User interface control failure | A switch on the user interface is defective. Replace the user interface | User interface control |
| Er-09 | Communication failure between the user interface control and the electronic control board | Shut off power to the dishwasher and check for loose wire connections between the user interface control and the electronic control board. If the wires and connections are intact, replace the user interface control. If the problem continues, replace the electronic control board | User interface control, electronic control board |
| Er-10 | Electronic control board relay failure | A relay on the electronic control board failed. Replace the electronic control board | Electronic control board |
| Er-12 | Drain valve position error | The drain valve activated when it should be off. Shut off power to the dishwasher. Check the drain valve wiring for a short. If the wiring is okay, replace the electronic control board because the drain valve relay likely is stuck. If the problem continues, replace the drain valve | Electronic control board, drain valve |
| Er-13 | Electronic control board failure | The electronic controlled board has an internal component failure. Replace the electronic control board | Electronic control board |
Electrolux Dishwasher Appliance Parts
Related Links
